Difference between revisions of "Begin"
(→6. Fahrzeugumbau) |
(→5. Control of Traffic) |
||
| Line 39: | Line 39: | ||
==5. Control of Traffic== | ==5. Control of Traffic== | ||
| − | For [[ | + | For [[Traffic control]] you can use [[traffic signals]].<br> |
| − | This [[ | + | This [[traffic signal decoder]] can be controlled with DCC addresses via a model railroad DCC capable controller.<br> |
| − | So you can | + | |
| − | + | So you can control the traffic signals with the PC.<br> | |
| + | Using [[:category:Tiny |Stoptiny]] or [[:category:Function-Modul]] stops the DC-Car.<br> | ||
==6. Vehicle Conversion== | ==6. Vehicle Conversion== | ||
Revision as of 00:37, 22 February 2017
The questions are: Where do I start?
or What do I need?
Contents
1. Video for instruction
Basic Video
The DC-car-System Video with a small Modellrailroad
More videos and pictures
2. Possibilities
There are many ways to use the DC-Car system:
Einstieg_in_das_DC-Car-System
Control without DCC adressing
Functiondecoder This can be use Address of Crossings.
More information Function-modul.
Control with DCC adressing
With Progset´s you can control the DC-Cars like a model railroad.
3. Request
Importend for controlling with PC is the request:Request-Modul
4. Turn Offs
To turn off of into a new direction, one needs a turn-off.
The simplest solution is with a servo driven turn-off. To control it one needs electronics to operate the servo.
Additional elecctronics, the Category:Function-Modul, DC-Cars get the turn signal instructions as a result of the turn-off being set.
Automatic Turn-offs with TINY
Using feedback sensors on can operate turnoffs from the vehicles themselves.
This works with Servotiny´s in a few turn-offs.
Automatic Turn-offs with Servos and Servo Decoder
Better than electromagnets/coils is using servo turn-offs and servo decoder.
Via the Inputprint on can operate servo decoders via feedback sensors.
The Advantage: By coupling a Servodecoder#S4DCC-Car with a function module one sends turn signal commands to the DC-Car's.
5. Control of Traffic
For Traffic control you can use traffic signals.
This traffic signal decoder can be controlled with DCC addresses via a model railroad DCC capable controller.
So you can control the traffic signals with the PC.
Using Stoptiny or category:Function-Modul stops the DC-Car.
6. Vehicle Conversion
Mechanical Conversion
[Welches_Modell_für_den_Anfang]
Electronic Conversion
As a first model, the [DC07-SI-LKW]] or DC07-SI-Bus is recommmended. Also see DC07-SI.
