Difference between revisions of "Inputprint"
m |
|||
| Line 1: | Line 1: | ||
[[File:S_Vorsatz_Anschluss_EN.png|right|400px]] | [[File:S_Vorsatz_Anschluss_EN.png|right|400px]] | ||
| − | ==Print this site[[File:Adobe_PDF_file_icon.png|link=http://www.modellautobahnen.de/pdf/ | + | ==Print this site[[File:Adobe_PDF_file_icon.png|link=http://www.modellautobahnen.de/pdf/Inputprint_EN.pdf]]== |
<br> | <br> | ||
==Switchboard for Servo- und traffic light decoder== | ==Switchboard for Servo- und traffic light decoder== | ||
Revision as of 00:49, 28 October 2017
Contents
Print this site
Switchboard for Servo- und traffic light decoder
The servo decoder from DC-Car (MoBa-Claus) can also be operated with a PC via the RS232 port.
Besides the progamm for the servo decoder, the CD also includes a program for operating the servos by mouse or keyboard.
With self-written programs it is feasible to implement some time-automatic sequences.
As another option for connecting to this interface is the so called switchboard.
The Prozessor get the signals from switch, reedswitch, Hallsensors or IR-Sensoren from (MINUS) and take it over RS232-chip to the connetion from the Servodecoder.
The positions off the servos are controlled with the programmer over the PC.
Controlled Servodecoders S4 and S8
Controlled Servodecoder W4
Controlled Traffic_signal_decoder
| 1 | 2 | 3-10 | 11+12 | 13 | 14 | 15 | 16 | 17 | 18 |
| + 5 V Out | - Ground | Trafficlight A - D | Call Light | Night | Nothalt | Start B | Start A | auto, off | auto. off |
| green red |
Instruktions
siehe Kit contruction inputprint
Servodecoder Traffic_signal_decoder
Ation
Hallsensors and R-Sensoren need a +5V connetion.
The left connector is 5V
use the servodecoder: with Extanionsconnector
| S8DCC/MOT up 01-02-2009 | W4DCC/MOT up 26-04-2009 | |
| S4DCC/MOT up 10-21-2008 | Traffic_signal_decoder up 10-2010 |
1. 
2. 
One screw is removed from the plug and the socket.<br
Then the assemblies can be plugged together and the ground connection is still given
If the switch is installed in a switchboard for the pushbuttons, a standard RS232 extension cable can be used
many servos with one switch
One switch can be used to operate several points simultaneously
The resistances should be 4.7 K and the diodes should be 1N4148
A control unit can be equipped with an RS232 cable (9-pin sub-D extension)
remote from the servo decoder.
