If the blue and red shift key simultaneously
pressed, the functions are "hidden" uses.
| |
The "hidden" commands are for special vehicles
such as buses. Thus, the control functions can be triggered.
In this way, with a few keystrokes, the
Bus stop realized.
e.g. at a bus stop, right flashing to stop , turn on the interior light,
Departure for waiting time, etc.
(depending on the CV-setting)
|
The transmitter 24plus is also a tester
1. infrared signal tester:
With the infrared sensor, the function of the IR LED sitting at the rear of a vehicle to be tested.
The probe is inserted into the charging socket of the transmitter.
Now hold the IR LED in the vicinity of the probe. The green LED on the transmitter will flash as 24plus
Sign that the car sent IR information.
This test can also be done with a second DC Car.
2. LED - Tester:
With the continuity tester that consists of a black and a red terminal, plugged into the charging socket, you can test and compare LEDs, IR LEDs. (uniform luminance)
Connect red to positive and black to negative an LED brings this zumeuchten.
In the DC-Car-LED the red wire is positive.
In normal LEDact the long terminal Plus
The green LED lights when the LED is working or has a short circuit.
If phototransistor are tested, they are illuminated by strong light. Then the green LED comes on.
3.Charge
To recharge the built-in battery charger with a 5 mm circular plug is required.
A DC voltage of 9-12 volts = should be applied for about 12 hours.
The high-quality NiMH batteries have a very low self-discharge.
The reloading every 4 weeks, as with other MiMH is not necessary.
The button is pressed power is used. Therefore, during transport to protect the keys.