Difference between revisions of "Bus automatic"
m (→Setting the DC Car) |
m (→Setting the DC Car) |
||
| Line 35: | Line 35: | ||
== Setting the DC Car == | == Setting the DC Car == | ||
| − | |||
| − | |||
Bus automatic: <br> | Bus automatic: <br> | ||
<Table> | <Table> | ||
| Line 51: | Line 49: | ||
<tr> <td> wait </td> <td>? </td> <td> CV103 Specify (0-63 seconds). Standard = 20 seconds </td> </tr> | <tr> <td> wait </td> <td>? </td> <td> CV103 Specify (0-63 seconds). Standard = 20 seconds </td> </tr> | ||
</Table> | </Table> | ||
| + | |||
| + | If you do not have your own setting option (digital control unit or CV-Programmer), you can also order the settings. <br> | ||
| + | When ordering, specify above mentioned CVs <br> | ||
[[Category:Software]] | [[Category:Software]] | ||
[[Category:Function_moduls,_Function decoders]] | [[Category:Function_moduls,_Function decoders]] | ||
Revision as of 08:02, 25 December 2017
Bus automatic with DC-Car
This is a automatic function in the DC-Car decoder to generate a bus stop with a minimum on hardware and no additional electronics.
There are two different conditions for a bus stop.
- Bus stop is next to the road
- or the bus stop is on the road
It is one or the other.
The function can be triggered via a hall sensor in the bus and two magnets in the road.
It is also possible to use the function module and have the control via IR LEDs.
It has to be informed to the vehicle what it should do.
One way to do both can be.
Set the bus to CV100 = 15. (with distance control!)
Place a function module SW in position 6 (F) in the bus stops.
To the entrance to the bus bay.
Exit 7 rear distance control.
At the exit
Exit 8 rear distance control on
'Disadvantage' in
The bus does not stop the flowing traffic before it wants to drive out again.
Thus, a Vorfahrtstiny VT becomes necessary.
When the bus starts, the Vorstinystiny stops the traffic.
see Automatic
Setting the DC Car
Bus automatic:
| Bus stop next to the road | O | IR OFF | CV100 = 14 |
| Bus stop on the road | O | IR-AN | CV100 = 15 |
Standstill:
| with interior light / working light = light2 | O | CV111 = 123 |
| without interior light / working light = light2 | O | CV111 = 1 |
| with hazard warning | O | CV112 = 3 |
| without hazard warning | O | CV112 = 0 |
| wait | ? | CV103 Specify (0-63 seconds). Standard = 20 seconds |
If you do not have your own setting option (digital control unit or CV-Programmer), you can also order the settings.
When ordering, specify above mentioned CVs
