Difference between revisions of "Bus-Station"
m (→General) |
m (→Verteilung der Busse) |
||
Line 23: | Line 23: | ||
Sometimes the platforms of the tram are shared. <br> | Sometimes the platforms of the tram are shared. <br> | ||
− | = | + | =Distribution of buses= |
[[File:DC-Car-Abzweig.png|190px|right|link=http://www.modelleisenbahn-claus.de/produkte-fuer-das-dc-car-system.html]] | [[File:DC-Car-Abzweig.png|190px|right|link=http://www.modelleisenbahn-claus.de/produkte-fuer-das-dc-car-system.html]] | ||
[[File:WDP4Wege.png|220px|link=Category:Windigipet]] [[File:S8_bestueckt.png|180px|link=W4]] [[File:S_Vorsatz_Anschluss_neu.png|170px|link=Inputprint]] [[File:Xt_baustein.png|150px|link=XT-Modul]]<br> | [[File:WDP4Wege.png|220px|link=Category:Windigipet]] [[File:S8_bestueckt.png|180px|link=W4]] [[File:S_Vorsatz_Anschluss_neu.png|170px|link=Inputprint]] [[File:Xt_baustein.png|150px|link=XT-Modul]]<br> |
Revision as of 13:00, 2 December 2017
General
Based on the term station, which is used for this railway, bus stops with several bus stops are called bus stations.
As a rule, the bus has only doors for the passengers on one side. Therefore, more bus platforms are needed.
There are different versions:
- Several bus platforms are approached directly from the main road
- After a driveway is distributed on the bus platforms
- Platforms can hold one or more buses
- For one bus we only set up a track
- For several buses we set up an alternative lane (fast lane).
- For one bus we only set up a track
- access
- It is turned 90 degrees into the stop
- at 45 degrees one speaks of a bus curve
- It is turned 90 degrees into the stop
= Types of buses =
- Low-floor buses hardly need elevated curbs
- Lowerable buses can be used at different heights.
- Buses with differently extendable entry levels also use high entry possibilities.
Sometimes the platforms of the tram are shared.
Distribution of buses
For the distribution of the vehicle, a servo can switch up to 4 ways.
Corresponding Servo turn outs are available for 3 or 4 ways, for wire or magnetic wire.
The required Servodecoder W4 offers operation via digital central unit or PC ( Windigipet even without control panel)
With an Inputprint and [[Rückmeldesensor|Feedback sensor] the buses can distribute themselves in order.
But if a particular bus should always arrive at its stop, the XT module is better.
It sets the servo according to the request from the bus Fahrzeugnummer 1-31|XT module # evaluation of vehicle number | vehicle number 1-31 in a maximum of 4 positions.