Difference between revisions of "XT-Modul-battery test"
m (→Values for the car decoder) |
m |
||
Line 1: | Line 1: | ||
− | [[File:xt_baustein.jpg|180px|thumb|XT- | + | [[File:xt_baustein.jpg|180px|thumb|XT-Module to be monted under the layout]] |
==Basics DC-Car-XT== | ==Basics DC-Car-XT== | ||
'''When it is set to: Evaluation of the battery test''' <br> | '''When it is set to: Evaluation of the battery test''' <br> | ||
Line 12: | Line 12: | ||
The sensor requires a photo transistor. <br> | The sensor requires a photo transistor. <br> | ||
It can be installed: <br> | It can be installed: <br> | ||
− | * In the | + | * In the delineators post |
* In the street as manhole cover | * In the street as manhole cover | ||
* As a sensor in a stationary vehicle | * As a sensor in a stationary vehicle |
Revision as of 08:29, 21 November 2017
Contents
Basics DC-Car-XT
When it is set to: Evaluation of the battery test
- Sorting out vehicles with an empty battery to reach a charging station (in conjunction with software fully automatic charging is possible).
Other options: see XT-Modul
Infrared transmit and receive
The sensor requires a photo transistor.
It can be installed:
- In the delineators post
- In the street as manhole cover
- As a sensor in a stationary vehicle
- hiding in trees, shrubs, buildings,...
Values for the car decoder
CV25 = 1 Transmitting from the back (via the IR LEDs for distance control) or
CV25 = 4 Side or bottom transmitter
CV26 Function of the vehicle with battery empty
CV27 = 2 or 10 battery test turned on
CV28 = 50 (1.2V) or 100 (2.4V) or 130 (3.6V battery)
DC-Car-XT-Modul
- Switching a 3-way servo turn out
- Switching a contact to ground / GND
- Transmitting a freely selectable DC Car Infrared command
You can choose whether the respective function is resetted after a certain time or by triggering a reed contact.
Pin assignment
Connection Description
DC voltage of 5V / 500mA via screw terminal block or the mini USB port.
- LED indicator
Green LED: 5V operating voltage available. Blue LED: received valid signal.
- Photo transistor (+ and -)
Note: Reverse marked as an LED.
- Servo connection
For direct control of a servo on the XT module.
Please pay attention to the correct connection sequence, as these might vary with the different manufacturers.
Setting XT module
...