Difference between revisions of "RmS88CarIR"
From wiki-en
(Created page with "=S88-Car-IR-Rückmeldedecoder= right Dieser Rückmeldedecoder hat 16 Eingänge die gegen Masse geschaltet werden.<br> Jeweils 2 Eingänge werden...") |
m (→S88-Car-IR-Rückmeldedecoder) |
||
| Line 1: | Line 1: | ||
| − | =S88-Car-IR- | + | =S88-Car-IR-feedback module= |
[[File:S88-Car-Ftr.png|400px|right]] | [[File:S88-Car-Ftr.png|400px|right]] | ||
| − | + | This feedback decoder has 16 inputs which are connected to ground. <br> | |
| − | + | Each 2 inputs are used for occupancy detection. <br> | |
| − | 1 | + | 1 occupied <bR> |
| − | 2 | + | 2 free <bR> |
| − | 3 | + | 3 occupied <bR> |
| − | 4 | + | 4 free <bR> |
| − | ...<bR> | + | ... <bR> |
<br> | <br> | ||
| − | + | The signal must come from DC-Cars. <br> | |
| − | + | IR LED on the back(used for anti collision system), side or bottom <br> | |
<br> | <br> | ||
| − | + | With 9 contacts 8 feedback should be recognized. <br> | |
<br> | <br> | ||
| − | + | Through a jumper a busy message without saving can be made. <br> | |
| − | + | Are all jumper set, the decoder performs like a standard S88-feedback module with 8 inputs. <br> | |
<br> | <br> | ||
<br> | <br> | ||
[[File:S88-Car_Anschl.gif|600px]]<br> | [[File:S88-Car_Anschl.gif|600px]]<br> | ||
<br> | <br> | ||
| − | + | Then is reported: <br> | |
| − | 1 | + | 1 is busy <br> |
| − | 1 | + | 1 open free <br> |
| − | 2 | + | 2 is not required <br> |
| − | 3 | + | 3 is busy <br> |
| − | 3 | + | 3 open free <br> |
| − | 4 | + | 4 is not required <br> |
...<br> | ...<br> | ||
<br> | <br> | ||
Revision as of 06:20, 11 January 2016
S88-Car-IR-feedback module
This feedback decoder has 16 inputs which are connected to ground.
Each 2 inputs are used for occupancy detection.
1 occupied
2 free
3 occupied
4 free
...
The signal must come from DC-Cars.
IR LED on the back(used for anti collision system), side or bottom
With 9 contacts 8 feedback should be recognized.
Through a jumper a busy message without saving can be made.
Are all jumper set, the decoder performs like a standard S88-feedback module with 8 inputs.
Then is reported:
1 is busy
1 open free
2 is not required
3 is busy
3 open free
4 is not required
...
