Category:Update socket

From wiki-en
Jump to: navigation, search

Spezial of updatesockets

Important for updates:

As a user, you can set the parameters of a vehicle or XT module with the CV-Programmer.
(This is not programming, but setting the allowed values)

Simple Programmer 1,2,7,8

For the simple programmers, the lines 1,2, 7, 8 on the 8-pin update socket are sufficient.
The vehicle must not be switched on because it is supplied by the CV Programmer with 4.3 volts.

Newer Programmer 1,2,6,7,8

In the new version, the lines 1,2, 6,7,8 necessary on the 8-pole update socket necessary RESET is used with one button before starting the programming mode.
Therefore, the vehicle decoder and the XT module may also be on.
Nevertheless, there is a supply of 4.3 V to set as usual not built-in components

leads for an update 1,2 3,4, 5 6

Lines 3,4,5 are required for updates by the DC Car Service.
Only here can the processor be programmed.
It is important that the blue lights on emergency vehicles are connected via resistors.
Without resistance, they are destroyed by 5 volts while programming.

Special feature DC06 (old decoder)

Since the DC06 normally only has 7 connections, most vehicles are only implemented with the programming socket 1-6.
This would be an update feasible, but no setting by the CV-Programmer This decoder has already been replaced by the DC08-I for some years. Therefore, there are no updates available.

Special feature DC04 (old decoder)

The DC04 has a smaller processor. Therefore, he has been replaced by the DC05. Hardware replacement
The DC05 can also be upgraded to the DC07.

Pages in category "Update socket"

The following 3 pages are in this category, out of 3 total.